GPSPATRON

GP-Probe has a self-diagnostic system built into all modifications. When an error is detected, the device displays an error code on the screen and sends the...

Only applicable to GP-Probe TGE2 Reason: Malfunction of RS-485 connection interface for remote control of GP-Blocker.  Solution: This is a hardware fai...

Only applicable to GP-Probe TGE2 GP-Probe TGE2 can operate with or without the GP-Blocker connected.  The device supports up to 4 connected GP-Blocker....

Reason: GP-Probe TGE2 built-in memory error. Solution: This is a hardware failure, but don't worry, it can be quickly repaired at our service center...

Reason: GP-Probe TGE2 GNSS port driver failure. Solution: This is a hardware failure, but don't worry, it can be quickly repaired at our service cen...

The GP-Probe TGE2 is equipped with a built-in current sensor that measures the consumption of a connected active GNSS antenna. The normal current consumptio...

There are two possible reasons for the GP-Probe TGE2 to indicate the error: Reason 1:  Short circuit in the GNSS antenna or RF cable. Solution 1: Re...

Only applicable to GP-Probe TGE2 Reason: The embedded spectrum analyzer (RFSA option) is not functioning properly.  Solution: If this is a recurring is...

GP-Probe TGE2 has a built-in module for measuring phase difference between internal and external PPS signals. You can enable the phase measurement function ...

Only applicable to GP-Probe TGE2 For proper operation of the spoofing and jamming detection algorithms, a sufficient signal-to-noise ratio and number of vi...